Disco 240 Dmx Controller Manual New! 95%

How many does your primary light fixture use?

Here is the core section from the manual, translated into a simple workflow to program a chase:

Mistakes happen. The Disco 240 allows you to clear individual scenes, entire banks, or reset the unit completely. Deleting a Single Scene Enter . Navigate to the target Bank using the Bank Up/Down buttons. disco 240 dmx controller manual

Use the and Scene (1–8) buttons to find the first scene you want in your sequence.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. How many does your primary light fixture use

Physical sliders used to alter the DMX values (0–255) of your fixtures.

Ensure you are using shielded DMX cables rather than standard XLR microphone cables, which lack the required impedance stability for data transmission. Can I run multiple chases at the same time? Deleting a Single Scene Enter

Even if your light only uses 8 or 14 channels, you must start it on these addresses (17, 33, 49, etc.). If you set a light to "Address 2," the Disco 240 will not control it properly because it is expecting channel 2 to be part of Fixture 1's 16-channel block.

For long runs, plug a 120-ohm terminator into the last light in the chain to prevent signal reflections.

Hold down the button for roughly 2 seconds. The PROGRAM indicator on the display will flash. B. Creating Scenes Enter Program Mode . Select a Bank (01-30) using the Up/Down buttons.

Adjust the to control how quickly the steps change.