Click the file selection button and load your target .bin firmware file.
The MKS DLC32 board is sensitive to voltage drops. Avoid using long USB extension cables. Use the short, shielded USB cable provided with your motherboard.
What or motherboard (e.g., DLC32, DLC V2.0) are you using?
MKS Laser Tool Setup v1.12.exe is a software tool designed to configure and calibrate laser cutting machines, specifically those using the MKS (Makerbase) controller. The software provides a user-friendly interface to adjust various settings, perform calibration, and optimize the laser cutting process.
Then, a soft beep. A dialog box popped up: mks laser tool setup v112exe download work work
Once you've downloaded the software, follow these steps to configure your MKS laser tool:
Configure the tool to establish seamless communication with your hardware.
MKS motherboards (like the DLC32) use the CH340 USB-to-serial interface chip. If your computer does not recognize the motherboard when plugged in, download and install the CH340 driver. Without this driver, the software cannot detect your COM port.
: Your USB cable might be power-only. Swap it for a certified USB data sync cable. Alternatively, try a different USB port, preferably a USB 2.0 port directly on your motherboard rather than a USB hub. Problem 2: Grayed-Out COM Port Selection Click the file selection button and load your target
If you've followed these steps and the MKS laser tool V112 is still not working, you might want to:
Subject: MKS Laser Tool v112.exe — Download & Setup Instructions
: You can find the installer on manufacturer sites such as Mecpow's Download Center or the LONGER3D GitHub repository.
Connect your laser engraver to your local wireless network. Use the short, shielded USB cable provided with
Set the to 115200 (the standard operating speed for MKS GRBL firmware).
💡 : If you are trying to configure a Robin Nano board, use the online Makerbase MKS-TOOL instead of the local .exe for easier UI customization. To help you get this running perfectly, could you tell me:
The MKS Laser Tool is a utility application designed by Makerbase. It acts as a bridge for firmware management and basic control of laser engravers using MKS mainboards (like the MKS DLC32). Key features of version 1.1.2 include:
If your controller experiences unstable motor translations or UI system errors, update the GRBL configuration: Choose the firmware flashing module within the application. Select your target motherboard layout (e.g., MKS DLC32).