Set IN Mode, UP = 14.4V (Stop charging), dn = 12.0V (Start charging).
Concluding note The XYCD60 manual is the definitive source for safe operation and getting the most from your device. Keep a copy accessible (digital or printed) and consult it whenever you perform maintenance or run into issues.
The device automatically cuts off charging when the battery reaches its full voltage (overcharge protection) and disconnects the load when the battery’s voltage drops too low (over‑discharge protection). Typical applications include solar storage systems, lead‑acid and lithium‑ion batteries for RVs and boats, off‑grid power systems, automotive and marine batteries, DIY electronics projects, and industrial control panels.
| Problem | Likely cause | Solution | |---------|--------------|----------| | No display | Input voltage <6V or reverse polarity | Check power supply wiring | | Relay chattering | Power supply unstable or near threshold | Stabilize input or widen hysteresis | | Wrong voltage reading | Calibration off | Re-calibrate with known meter | | Load stays off after fault | P6 delay not elapsed or P1/P3 values too tight | Wait or adjust thresholds | xycd60 manual
A: No, it cannot. The XY-CD60 is a simple voltage controller and a switch, not a voltage regulator. It turns the output on and off based on pre-set voltage thresholds but does not alter the voltage itself.
As I looked down at my hands, I realized they were no longer human. I was one of them now, a being capable of transcending the boundaries of species, of time, and of space. The manual, it seemed, was not a guide but a catalyst.
LCD screen showing voltage, percentage (calculated as Set IN Mode, UP = 14
If OP is set, the relay will automatically disconnect after the specified duration, even if the voltage threshold hasn't been reached. This acts as a safety backup.
6V - 60V (Handles 12V, 24V, 36V, 48V systems) Max Current: Up to 10A (Continuous) Modes: Charging (IN) / Discharging (OUT) Display: 3-digit Segment Display Protection: Reverse Polarity Protection 2. Interface and Button Functions The module has four main buttons for navigation:
The (and its variant ) is a specialized battery charging and discharging control module designed for a wide voltage range of DC 6V to 60V . It serves as an intelligent switch that prevents battery damage by cutting off the circuit when specific voltage thresholds are reached. 1. Core Functionality and Operating Modes The device automatically cuts off charging when the
The XY-CD60 features a clean LCD layout and three simple navigation buttons: UP , DOWN , and SET .
Short press to turn ON/OFF output, long press to turn on/off power-saving mode (L-P). Voltage Display: Shows input voltage or settings. 3. Operating Modes (IN / OUT)
The module features two core programmatic profiles. Selecting the right profile dictates how the physical relay responds to voltage changes. 1. Charging Control Mode ( IN )
Connect the to the IN terminals and the load to the OUT terminals.