Xmtd-2201: Manual [updated]

For more detailed technical data on the XMTD-D Series , you can review the manufacturer's specification sheet.

XMTD-2201 Manual : Comprehensive Guide to Installation, Wiring, and Setup The Go to product viewer dialog for this item.

The hardware layout supports different factory calibrations depending on your production requirements. Check the side label of your specific unit to match its preconfigured sensor variant:

4-digit red LED display showing the current measured temperature. xmtd-2201 manual

Adjustment Mode (Three-position or Proportional setting). 0: No Alarm. 1: Output Mode (Relay Contact Output). Power Supply: Measurement Accuracy: Input Types: Thermocouple (K, E) or RTD (Pt100, Cu50). Output Capabilities: 3A at 220V (Resistive Load). Ambient Conditions: 0–50°C,

The XMTD-2201 has various sub-models (like -F1 , -E 400.c , -K 1300.c ), each with specific inputs and functions. Always check the label on your specific device.

Controller powers on but does not heat. Check: Is the OUT LED lit? For more detailed technical data on the XMTD-D

The relay terminals are used to turn on/off the heater or cooling unit.

Proper installation is critical for safety and accuracy. Always disconnect power before wiring the device to avoid electric shock.

| Terminal # | Signal | Wire Color / Note | | :--- | :--- | :--- | | 1 & 2 | Power (100-240VAC) | Brown (Live), Blue (Neutral) | | 3 & 4 | Alarm 1 Relay (NO) | Normally Open (3-4 close on alarm) | | 4 & 5 | Alarm 2 Relay (NO) | Share common terminal 4 | | 6 & 7 | Sensor Input (- / +) | Thermocouple: Red (-), Yellow (+) | | 7 & 8 | Sensor Input for RTD | For Pt100: 7 & 8 shorted via one lead | | 9 & 10 | Control Output | SSR: 12VDC (polarity sensitive) OR Relay | Check the side label of your specific unit

If the controller is not working correctly, check these common issues before assuming the unit is broken.

Thermocouples (K, J, E, S, T) and RTDs (Pt100, Cu50)

Green digits showing the target temperature setting or menu parameter names.

+------------------------------------+ | 1 2 3 4 5 6 7 | | [ALM] [ POWER LN ] [ OUT ] | | | | 8 9 10 11 12 13 14 | | [ TC/RTD ] [ SSR ] | +------------------------------------+ Use code with caution. 1. Power Supply